Labconco Protector Controlled Atmosphere Glove Box User Manual download pdf (Page 20)

Chapter 3: Getting Started

Product Service 1-800-522-7658

Installation of Gloves to the Glove Ports

With the thumbs up and in a right/left orientation, secure the gloves in place

on the glove ports by stretching the beaded glove cuff into the glove port

groove nearest the window. Install the separate 8" diameter O-ring over the

gloves, into the outer groove of the glove port surface. Stainless steel band

clamps are provided for securing the separate O-ring into the glove port

groove. Replacement gloves and parts are listed in Chapter 7.

Figure 3-3

Glove Installation

Connecting the Electrical Supply Source to the

Glove Box

Connect the power cords supplied to both IEC electrical supply plugs located

on the back of the glove box. For doublewide models, connect one extra

power cord for the centrally located duplex on the left side. 100-115V

models are rated at 12 amps for each power cord. 230V models are rated at

12 amps for one power cord and 6 amps for the other power cord to power

the exterior vacuum pump outlet. The maximum circuit load for the

interior electrical duplex is 10 amps. The exterior vacuum pump receptacle

is rated at 8 amps for 100-115V models and 4.5 amps for 230V models. On

auto pressure control and combination models, a foot switch for pressure

control is supplied and is connected (3 position connector) to the back of the

glove box as marked. See Figure 3-2 for all electrical connections. See

Figures 1-1 and 1-3 for foot switch.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 79 80

No comments

Labconco Protector Controlled Atmosphere Glove Box User Manual Page 20